Water bladder- 2 litres - trail running

With its 2L capacity, your water bladder will give you 4 hours of running time on average.And thanks to its wide open, you can quickly fill it at the drink stations. When closing it, you should feel the slide-top clip into place to ensure a perfect seal. Finally, the water bladder is compatible with the 15L trail running bag.

You can easily cut the tube of the water bladder to your preferred length!To do this, remove the bite valve, put the tube in some hot water to soften it, cut it to the required length and replace the bite valve.The bite valve has an on/off closure system to prevent leaks during transportation. When running, it does not leak, even when it is in the open position. In order to get a good flow rate when you drink, pinch the bite valve with your mouth and suck!

The components of your water bladder are guaranteed to be free of BPA (Bisphenol A) in accordance with current French regulations.It is 38 x 18cm in size with a 100cm tube.To prolong the lifetime of your water bladder, do not fold it, do not fill it with hot liquids and do not carry it upside down or by the tube ;)

To avoid hearing the noise of the water splashing about in the pouch while you are running, make sure you empty out all the air before starting!Just hold your water bladder upside down after filling it, guide the air bubbles towards the tube opening and suck them out. That's all there is to it. Now you can enjoy the silence while you run!

To avoid any taste of plastic when you drink, rinse your water bladder 3 times before using it for the first time.Whenever you clean your water bladder, remember to dry it thoroughly by leaving it open.If the taste of plastic persists, put your dry water bladder in the freezer overnight.

To validate the quality of the 2L water bladder, it was tested in our in-house laboratory on a mannequin that replicates 1000 km of running with impacts. No faults were recorded and the product worked perfectly.